2 - Mounting points The mounting points, which are linked
to the drive system by cables and pulleys, support and guide
the cables along the path between the supports and the drive
system.
4
- Stabilisers
The stabilisers positioned at intervals along the length of
the structure are used to adjust and centre the movable floor.
They prevent the floor from swinging from side to side when
in a raised or intermediate position.
They
form the interface between the drive system and the movable
floor.
1 - Structure The structure is made of rectangular
tubes that are assembled and welded in the factory. These
elements are then assembled on site and bolted together to
form a framework. The finishing covering is then attached
to the assembled structure.
This process allows the equipment to be transported and assembled
on-site more easily.
5
- Drive system The drive system uses a worm gear
and sealed gearbox to pull the cables to which the floor is
attached. The cables guide the path followed by the anchor
disk as it moves horizontally. The length of the worm gear
matches the depth of the pool up to the coping boards.
Sealed limit switches stop the floor's movement when it reaches
the surface or the bottom of the pool. The drive system is
controlled by a control unit that enables the platform to
be stopped at the desired height.
6 - Adjustable feet The feet located at intervals below
the structure prevent vertical oscillation and stabilise the
floor when the system is lowered to the bottom of the floor.
3
- Cable supports The cable supports fitted underneath
the structure, hold the cables in position along the inside
wall of the pool, and allow the level to be adjusted when
the movable floor is installed.
7 - Inspection hatch An inspection hatch provides access
for a cleaning robot to clean the pool bottom, or to allow
servicing by a maintenance technician.
SYSTEM
SPECIFICATIONS
Safe working load
: 100 kg /sq.m Standard water depth : 1.60 m (greater
depths on request). Movement speed : 1 m /minute. Control unit : Remote-mounted, key-lockable
"press-and-hold" button unit. Power supply : Single-phase 220 V or
three-phase 380 V. Cables and fittings : Ø6 mm,
316L grade stainless steel Frame : 150 mm x 50 mm x 2 mm stainless
steel tubes. Accessories : Stainless steel (or hot-galvanized
steel for non-submerged parts) Finishing covering : Exotic wood, PVC,
tiling or other finish. Swimming pool safety standard : NFP
90-308
Design - Engineering - Manufacturing of movable pool floors
165, chemin de la Grand' Plaine - 83500 La Seyne sur Mer - FRANCE
Tél : +33 (0) 9.51.82.18.51 - Fax : +33 (0) 4.94.94.60.35 - Mobile : +33 (0)6.22.35.42.34
SIRET 509 038 733 RCS Toulon
